Advertisement
Quick Links
Installation and technical manual
Panel Heater CPH 1000 – 2400 E - Stands
CPH 1000 E
CPH 1500 E
CPH 2000 E
CPH 2400 E
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE
REFERENCE. BE SURE TO OBSERVE ALL LABELS AND WARNINGS ON THE APPLIANCE
Edition: 01/18
Id Nr. 911 360 860
Eco-Design Directive 2015/1188:
This product is only suitable for well-
insulated rooms or for occasional use.
D
GB
Advertisement
Related Manuals for Technotherm CPH 1000 E
Summary of Contents for Technotherm CPH 1000 E
- Page 1 Installation and technical manual Panel Heater CPH 1000 – 2400 E - Stands CPH 1000 E CPH 1500 E CPH 2000 E CPH 2400 E Eco-Design Directive 2015/1188: This product is only suitable for well- insulated rooms or for occasional use.
- Page 2 Manual CPH 1000 - 2400 1. For your safety • This appliance is intended for normal household use and not for use for vehicles or on board ships or aircrafts. • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction...
- Page 3 Manual CPH 1000 - 2400 • CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. • Make sure that your supply rating corresponds to what specified on the rating plate: 230V~, 50Hz.
- Page 4 Manual CPH 1000 - 2400 Warning! This device has to be grounded This device may only be operated using alternating current and the operating voltage indicated on the power rating plate. • Nominal Voltage 230V AC, 50 Hz • Protection Class •...
-
Page 5: Important Notes
Manual CPH 1000 - 2400 Switching the appliance off Switch off the appliance by setting the tumbler switch to position „0“. 3. Important notes During operation the temperature at the front panel and at the hot-air outlet of the convector may rise above 85 °C. -
Page 6: Electrical Installation
Manual CPH 1000 - 2400 Electrical installation The appliance has been designed to be connected to 230V alternating current (AC). All electrical installation work, in particular protective measures, must be carried out in compliance with the national regulations and statutory provisions of the respective utilities provider. The electrical installation may only be carried out in compliance with the installation instructions by an authorized professional! Permanent cables must not be connected directly to the appliance! If the electrical installation is done by... - Page 7 Lucht LHZ Elektroheizung GmbG & Co. KG | Reinhard-Schmidt.Str.1 D-09217 Burgstädt Failure to comply with these requirements will result in the loss of the CE mark. TECHNOTHERM Support: Fon: +49 (0) 911 937 83 210 Lucht LHZ Elektroheizung GmbH & Co. KG Reinhard-Schmidt-Str.