Download Print this page

Kolcraft baby's 1st jeep Instruction Manual

Rocker

Advertisement

Quick Links

READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF PRODUCT.
Failure to follow warnings and instructions could result in injury or death to your child.
Make sure rocker is fully assembled and secure before use.
• STOP using rocker when your child is 36 months or weighs more than 45 lbs (20.41 kgs).
• To prevent injury from falls:
• NEVER leave your child unattended.
• NEVER use on any elevated surface.
• ALWAYS use restraint until child is able to climb in and out of the chair unassisted.
• Use the upright position only when child can sit up unassisted.
• NEVER lift rocker while child is seated.
• DO NOT lift by toy bar.
• NEVER use rocker as a car seat; it will not protect your baby during an accident.
AVOID STRANGULATION HAZARDS:
• DO NOT place items with a string around child's neck (pacifier cords, hood strings, etc.).
• DO NOT allow strings to hang into bouncer, including blind cords or suspended toys other than
what is provided with this product.
• DO NOT use around pets or other children.
• DO NOT continue using infant rocker if it becomes bent, broken or if the cloth cover is
ripped or torn.
PARTS LIST:
© 2003 Kolcraft
®
Enterprises, Inc. All rights reserved.
B
ABY
by
WARNING
!
Keep these instructions for future reference.
Frame
'
1
J
R
S
ST
EEP
OCKER
®
Toy Bar
1
I
NSTRUCTIONS
!
Infant Headrest
Seat Pad
R02J-A
R02J-A 3/03

Advertisement

loading

Summary of Contents for Kolcraft baby's 1st jeep

  • Page 1 • DO NOT continue using infant rocker if it becomes bent, broken or if the cloth cover is ripped or torn. PARTS LIST: Frame Infant Headrest Toy Bar Seat Pad © 2003 Kolcraft ® Enterprises, Inc. All rights reserved. R02J-A 3/03...
  • Page 2 How To Assemble Your Rocker TO INSTALL BATTERIES IN VIBRATOR: Step 1. Insert a flat head screwdriver tip into battery door located underneath vibrator. Release tab, and gently push tab back and up to release. CAUTION Remove battery before storing the product for a prolonged period of time.
  • Page 3 Step 4. Pull fabric over vibrator. Step 5. Flip rocker over. Feed straps through “D” ring and secure as shown. TO INSTALL TOY BAR & INFANT HEADREST: Step 1. Lift red buttons on both sides of toy bar and fasten onto frame as shown.
  • Page 4 How to Properly Use Your New Rocker TO FASTEN RESTRAINT SYSTEM: Step 1. Place child in the seat. Position restraint system between legs. Step 2. To fasten restraint system buckle, push buckles together as shown. Step 3. To adjust restraint system, loosen or tighten loop of restraint to fit snugly around child’s waist.
  • Page 5 INFANT ROCKER USE POSITION: Adjust rocker into the semi-recline position. To adjust seat, pull up on wire lever and adjust seat back to the middle upright position. IMPORTANT! Use the upright Toddler position only when child can sit up unassisted! Infant Position Stationary Feeding Position Your rocker also has a stationary bar...
  • Page 6: Care & Maintenance

    Some regions do not allow the exclusion or limitation of warranties set forth above, so the above exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights. We sincerely thank you for your purchase of this KOLCRAFT product.