Dynojet Power Commander V Installation Instructions Manual page 6

FIG.J
FIG.K
FIG.L
15-013 w ww.powercommander.com
3
Diag plug
4
5
7
8
9
10 Reinstall the side cover.
Using the supplied velcro install the Autotune module inside the electrical box
next to the ECM per Figure J.
Make sure the velcro does not cover the designation of the sensor inputs on
the back (#1 or #2). The inputs are coded to the front and rear cylinders.
Connect the longer harness to the front O2 sensor. Route the harness along
the front down tube and along the backbone of the frame to Autotune input #1.
Wire the harness to the module per Figure K. The harness can be cut to length
if desired.
Repeat step 4 for the rear cylinder. Wire the harness to Autotune input #2. The
harness can be cut to length if desired.
Use the CAN bus cable to connect the Autotune module to the PCV. It does
not matter what ports are used.
Install the CAN termination plug into the open port of the Autotune module.
This is the BLACK plastic connector in the kit
Secure the harnesses in place as to not contact the exhaust.
In the PCV software go to Power Commander Tools - Configure - Auto tune to
enable the unit.
Go to www.powercommander.com for maps and software updates.
2010-2011 Harley Davidson Dyna PCV - 6