Dynojet Power Commander V Installation Instructions Manual page 5

FIG.G
FIG.H
FIG.I
15-013 w ww.powercommander.com
O2 eliminator
Diag plug
15 Unplug the rear O2 sensor from the stock wiring harness. This connector is
located in the opening of the frame under the seat.
16 Plug the Dynojet O2 sensor eliminator into the stock wiring harness (Fig. G).
The stock O2 sensors will not be connected to anything at this time. If using
the Autotune kit (part #AT-100) remove the stock sensor and replace with the
Dynojet O2 sensor.
17 Install the PCV in the opening of the of the frame under the seat. You can use
the supplied velcro or a zip tie to secure the unit if desired.
Follow these instructions when using the Auto tune kit - part #AT-100
1 Remove the left hand side cover.
2 Remove the rubber plug for the stock diagnostic plug. Plug the power lead
from the Autotune module into the diagnostic plug (Fig. I).
2010-2011 Harley Davidson Dyna PCV - 5