Dynojet Power Commander V Installation Instructions Manual page 3

FIG.A
FIG.B
FIG.C
15-013 w ww.powercommander.com
Unplug
Ground wire
Stk connector
1 Remove the seat
2 Remove the left hand side cover (Fig. A).
3 Unplug the stock wiring harness connector from the ECM (Fig. B).
4 Move the data plug out of the way to access the bolt.
5 Remove the 3 bolts that hold the electrical box in place (Fig. B).
6 Slide the plastic box out from the frame.
7 Route the stock connector through to the back side of the electrical box
(Fig. C).
2010-2011 Harley Davidson Dyna PCV - 3