Erasing Diagnosis Codes; When Using The Mut-Ii; When Not Using The Mut-Ii - Mitsubishi PAJERO Workshop Manual

35B-6
www.WorkshopManuals.co.uk
ON
Ignition switch
LOCK (OFF)
ON
Stop lamp switch
OFF
ON
ABS warning
lamp
OFF
Trouble code memory
ABS <4WD> -

ERASING DIAGNOSIS CODES

When using the MUT-II

Connect the MUT-II to the diagnosis connector and erase
the diagnosis codes.
Caution
Turn the ignition switch to the LOCK (OFF) position when
connecting and disconnecting the MUT-II.
NOTE
Connect the MUT-II to the 16-pin diagnosis connector.

When not using the MUT-II

(1) Stop the vehicle.
(2) Turn the stop lamp switch to ON (brake pedal depressed).
(3) In this condition (after carrying out steps 1) to 2)), turn
NOTE
If the functioning of the ABS-ECU has been stopped by the
fail-safe function, the diagnosis codes cannot be erased.
With-
With-
in 1 s
in 1 s
Within 3 s
1st
2nd
Purchased from www.WorkshopManuals.co.uk
Troubleshooting
the ignition switch to the ON position. Then turn off the
stop lamp switch (release the brake pedal) within 3
seconds, and then turn the stop lamp switch on and off
again a further 10 times.
With-
With- With-
With-
With-
in 1 s
in 1 s in 1 s
in 1 s
in 1 s
3rd 5th 7th
4th
6th
1 s
With-
With- With-
in 1 s
in 1 s in 1 s
9th
Erasing
10th
8th
complete