Center Differential Lock Switch System; Rear Differential Lock Switch System - Mitsubishi PAJERO Workshop Manual

www.WorkshopManuals.co.uk
<Vehicles without rear differential lock system>
Code No. 26 Center differential lock switch system
Code No. 27 Rear differential lock switch system
The ABS-ECU is designed to accommodate the fitting of a rear differential lock.
Because of this, for vehicles which are not equipped with a rear differential lock,
system voltage is applied to terminal (33) of the ABS-ECU instead of the rear
differential lock switch signal. If there is an open circuit in the lines by which this
system voltage is applied, the ABS-ECU outputs code Nos. 26 and 27.
Measure at ABS-ECU connector E-107.
D Disconnect the connector and measure at the harness
side.
D Ignition switch: ON
D Voltage between terminal 33 and body earth
OK: System voltage
Check the following connector: E-107
OK
Check the trouble symptoms.
NG
Replace the ABS-ECU.
ABS <4WD> -
OK
NG
Repair
Purchased from www.WorkshopManuals.co.uk
Troubleshooting
Probable cause
D Malfunction of harness or connector
D Malfunction of the ABS-ECU
NG
Check the following connector: D-32, D-124, D-208, D-210,
E-13, E-107, F-17
OK
Check the trouble symptoms.
NG
Check the harness wire, and repair if necessary.
D Between the ignition switch and the ABS-ECU
35B-11
NG
Repair