Page 1
Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. CD-E250E Mini Component System consisting of CD-E250E (main unit), MINI COMPONENT SYSTEM CP-E250E (front speakers) and GBOXS5001SJB1 (surround speakers).
Page 2
Where plug destroyed immediately and disposed of in a safe manner. this is not possible, please visit our web-site www. sharp.co.uk/ Under no circumstances should the cut-off plug be inserted else- customersupport.
25. CD Track Up or Fast Forward, Tape 2 Fast Forward, Tuner Preset Up Button ..... . 16, 20, 21 03/2/17 CD-E250E(E)1.fm Downloaded From Disc-Player.com Sharp Manuals...
Page 7
1. Tweeter 2. Bass Reflex Ducts 3. Woofer 4. Speaker Wire ! Surround speaker 1. Full-Range Speaker 2. Speaker Wire Note: The speaker grilles on the front and surround speakers are not removable. 03/2/17 CD-E250E(E)1.fm Downloaded From Disc-Player.com Sharp Manuals...
Page 8
21. Volume Up and Down Buttons ......13 Buttons with " " mark in the illustration or highlighted in bold on the right can be operated on the remote control only. 03/2/17 CD-E250E(E)1.fm Downloaded From Disc-Player.com Sharp Manuals...
This will prevent potential damage due to battery leak- age. Caution: " Do not use rechargeable batteries (nickel-cadmium battery, etc.). " Installing the batteries incorrectly may cause the unit to malfunc- tion. 03/2/17 CD-E250E(E)1.fm Downloaded From Disc-Player.com Sharp Manuals...
" Do not allow any objects to fall into or to be placed in the bass reflex ducts. " Do not stand or sit on the speakers. You may Incorrect be injured. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
Page 12
Caution: The speaker may fall if mounted improperly. Check the stability of After use: the wall thoroughly. Sharp is not liable for accidents caused by poor Press the ON/STAND-BY button to enter the power stand-by wall stability or improper mounting.
Bass and treble are slightly emphasised. Press the VOLUME (+ or -) button to increase or decrease the vol- ume. Vocals (midrange tones) are emphasised. VOCAL Treble is slightly emphasised. JAZZ ..29 30 (MAXIMUM) 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
[Refer to "Clearing all the memory (reset)" on page 29 for details.] 1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 29 for details.] 2 Perform "Setting the clock" from step 1. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
CD player will automatically stop. " When there is no CD in one of the disc 1 - 3 positions, that position will be skipped and the next CD will begin to play. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
! If a disc is damaged, dirty, or loaded upside down, the disc will paused. When the beginning of the first track is reached during skip or not play back. fast reverse, the unit will enter the playback mode. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
Press the button again. " " will go out. Caution: After performing repeat play, be sure to press the button. Other- wise, the disc(s) will play continuously. To cancel random play: Press the button. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius. Correct 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
FM stereo mode indicator FM stereo receiving indicator ! If the FM reception is weak, press the TUNER (BAND) button to extinguish the "ST" indicator. The reception changes to monau- ral, and the sound becomes clearer. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
Page 20
When a new station is stored in memory, the station previously memorised will be erased. Note: The backup function protects the memorised stations for a few hours should there be a power failure or if the AC lead is discon- nected. 03/2/17 CD-E250E(E)2.fm Downloaded From Disc-Player.com Sharp Manuals...
In this case, wait until the power is restored. ! Even if the button on the remote control is pressed during tape playback, the unit will not enter the pause mode. 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
Side A ! When recording on a cassette tape, ensure that the desired material is properly recorded. ! SHARP is not liable for damage or loss of your recording arising make sure that the erase-prevention tabs are not removed. Cassettes have from malfunction of this unit.
Press the button. Note: Note: Make sure that the TAPE 1 is not in use. If you hear a whistling noise whilst recording an AM station, move the AM loop aerial. 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
Press the TIMER/SLEEP button repeatedly to select timer playback or timer recording and within 8 seconds, press the MEMORY/SET button. Display the white " " for timer playback and the red " " for timer recording. White 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
Page 25
The volume will increase gradually until it reaches the volume you were listening to before your system entered the timer stand-by mode. The unit will enter the stand-by mode one hour after the timer playback or recording starts. 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
Press the ON/STAND-BY button whilst the sleep timer is set. To confirm the remaining sleep time: Press the TIMER/SLEEP button whilst the sleep timer is set. The remaining sleep time is displayed for about 8 seconds. 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
16 ohms and 50 ohms impedance. The recom- mended impedance is 32 ohms. " Plugging in the headphones disconnects the speakers automati- cally. Adjust the volume using the VOLUME buttons. 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
Symptom Possible cause If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre. " The radio makes unusual " Is the unit placed near the TV or noises continuously.
Page 29
Make sure that "NO DISC" is displayed. 5 Press the ON/STAND-BY button to enter the stand-by mode, and then unplug the AC power lead from the wall socket. 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
Specifications CD-E250E ! Cleaning the tape-handling parts As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product " Dirty heads, capstans or pinch rollers can cause poor sound and improvement without prior notice. The performance specification fig- tape jams.
Page 31
10 W 50 dB (TAPE 2, recording/playback) Impedance 16 ohms Wow and flutter 0.3 % (WRMS) Dimensions Width: 195 mm (7-11/16") Height: 100 mm (4") Depth: 140 mm (5-1/2") Weight 0.7 kg (1.5 lbs.)/each 03/2/17 CD-E250E(E)3.fm Downloaded From Disc-Player.com Sharp Manuals...
3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed Service Facility within one year from the date this product was purchased. Proof of purchase must be provided.