1. Package Contents Thank you for choosing PLANET 600M AV2 Powerline Ethernet Bridge, PL-802/PL-802-KIT. Open the box of the PL-802/PL-802-KIT carefully and unpack it. The box should contain the following items: PL-802 Ethernet Cable Quick Install Guide (Twin pack x 2)
3. Physical Introduction Port & Button Descriptions 10/100BASE-TX Ethernet RJ-45 Port Security Button Button Description Reset: Hold the Security button down for 10 seconds to reset to default setting. All of the LED lights will go out 1 second and then light up again. Security Pair: Press the Security button for 1~3 seconds to join another powerline network.
LED Descriptions Power LED Ethernet LED Powerline LED LED Definition Status Description Steady on to indicate the PL-802 is connected to Green the power outlet. Blinking Standby mode. Power Power off. This powerline adapter is not connected. The quality of signal is excellent with optimal Green network.
Step 1: 1. Plug the Powerline Ethernet Bridge into AC wall power outlets near the device you want to connect. 2. Plug the PL-802 into AC wall power outlet in your room or office where you want to install. 3. Ensure the Power LEDs are on.
Page 6
Step 2: To secure your powerline network: 1. Press and hold the Security button of PL-802 for 10 seconds. Then all the LEDs are off and restart. The original network encryption setting is cleared. 2. Repeat 1 to clear another powerline’s original network encryption setting.
Step 3: 1. Connect the Ethernet port of PL-802 to your home router, switch or ADSL modem’s Ethernet port via the RJ45 cable. 2. Connect the Ethernet port of the PL-802 to the computer via the RJ45 cable. Internet Linked Laptop 6.
Windows 7, Windows 8 and Windows 10. Note Further Information: The above steps introduce the simple installations of the PL-802. For further details on the installation of the powerline, please refer to the user manual which can be downloaded from the PLANET website.