Recording Your Quick Assist Voice Messages; Number Of Inputs; Message Delay On Tx; Quick Assist Messages - Ritron Quick Talk RQA-451 Owner's Manual

R Y Q
ECORDING OUR UICK
®
The Quick Assist can be programmed to play two unique
voice messages, an "Assistance needed" message that is
transmitted when the front panel push button is pressed, and
a "Call answered" message that is transmitted if the Quick
®
Assist has been reset.
Voice messages can be recorded into the Quick Assist
using the RQA/RQT PC Programmer and the electret
condenser microphone built onto the radio PCB assembly.
Voice messages can also be recorded with an incoming
audio signal from you computer. This allows you to record
and store a message onto your computer and use it for
®
multiple Quick Assist transmitters.

Number of Inputs

The number of inputs is fixed at 1 for Quick Assist

Message Delay on TX

Whenever the Quick Assist
wait this length of time before the alert tones and recorded
voice message are sent.
®
Quick Assist Messages
A total of 24 seconds is allocated for Quick Assist
messages, 12 seconds for the RQA Message and 12
seconds for the Reset Message.

Low Battery Message

When it senses the installed batteries are nearly run down,
®
Quick Assist will transmit one time each hour the factory-
programmed message: "Low Battery". If you maintain
®
several Quick Assist transmitters within radio range of each
other, you may customize this feature to easily determine
which unit needs new batteries.
If you use only one Quick Assist
regularly change Quick Assist
programmed message may be sufficient for your application.
For assistance, call RITRON at 800-872-1872, or go to
®
A V M
SSIST OICE ESSAGES
®
.
®
transmitter is activated it will
®
voice
®
in any area, or if you
®
batteries, the factory-
........................................................................................

Power Fail Message

When the Quick Assist
external +12VDC supply and batteries are
installed as a back-up, the RQA will transmit the
Power Fail Message on a scheduled basis as long
®
as the +12VDC external supply is not detected.

Location Message

When installing more than one Quick Assist
single frequency it may be desirable to record a
unique Location Message to identify each
individual Quick Assist
will be played after the TX Alert Tone and before
the RQA Message.
To record your Quick Assist
1. Read existing radio programming.
2. Enter the Number of Inputs you will be using.
3. Select the messages you will be recording.
4. Enter Message Delay on TX time.
5. If there were any changes made during steps
2 through 4, press the COMMIT button. This
will erase all input messages, they will have to
be re-recorded and the RECORDED boxes
will no longer be checked.
NOTE: Pressing COMMIT button will not
erase the Low Battery, Power Fail, or
Location messages.
6. To record a new message, press the desired
RECORD button and follow the instructions
on the Record Message dialog box.
7. The RECORDED checkbox will now indicate
that the message is recorded.
After you have recorded the message you can
review by pressing the associated PLAY button.
The Quick Assist
the transmit frequency associated with the input
selected.
www.ritron.com
®
is powered with an
®
. The Location Message
®
Voice Messages:
®
will transmit the message on
®
on a
10