Quick Assist ® Default Programming - Ritron Quick Talk RQA-451 Owner's Manual

Repeat Message with multiple transmissions
You can set a limit to the number of times the message
will be transmitted at the scheduled intervals.
Example: Suppose you have placed a Quick Assist
the delivery door of your building. Your recorded
message might then be "Visitor at Delivery Door". You
may want this message to be transmitted every two
minutes for approximately a quarter hour after the push
button has been pressed, and then to stop transmitting
until the button is pressed again. In this case, you would
program the message Wait Time for every two minutes,
and set the Message Limit to "8", as described here.
®
Q A D
UICK SSIST EFAULT
TX Frequency
QC/DQC Code
DQC Invert
Compand
Reset Operation
Reset Button Hold Time
Input Operation
Latching Input Mode
Debounce/Holdoff Time
Number of Inputs
TX Alert Tone
Battery Saver
Low Battery Message
Power Fail Message
Message Delay on TX
Recorded Messages
Number of Times Recorded Message
is repeated on each Transmission
Number of Times the Transmission is sent
Wait Time between Transmissions
For assistance, call RITRON at 800-872-1872, or go to
®
at
P ..........................................................................................................
ROGRAMMING
RQA-151 24
RQA-151M 22
RQA-451 26
44
No
No
Reset from Front Panel Button
5 sec.
Normal
Yes
10 sec.
1
Yes
Yes
Yes
No
1 sec.
RQA Message "Assistance needed"
Reset Message "Call answered"
Power Fail "Power fail"
Low Battery "Low battery"
1 time
2 times
30 seconds
When the push button is pressed the message is
transmitted every 2 minutes until it has been sent 8
times over a span of 16 minutes.
®
The Quick Assist is set at the factory to transmit the
recorded message twice with a 30 second Wait Time in
between transmissions.
Wait time between repeated transmissions
This sets the amount of time the Quick Assist
between repeated transmissions.
151.625 MHz
154.600 MHz
467.850 MHz
No Tone
www.ritron.com
®
will wait
7