Sony CMT-BX50BTi Operating Instructions Manual page 2

WARNING
To reduce the risk of fi re or
electric shock, do not expose
this apparatus to rain or
moisture.
CAUTION
Th e use of optical instruments with this
product will increase eye hazard.
Notice for the customers in the U.S.A
Th e following CAUTION marking is
located on the rear exterior.
Th is symbol is intended
to alert the user to the
presence of uninsulated
"dangerous voltage" within
the product's enclosure
that may be of suffi cient
magnitude to constitute
a risk of electric shock to
persons.
Th is symbol is intended
to alert the user to the
presence of important
operating and maintenance
(servicing) instructions in
the literature accompanying
the appliance.
GB
2
CMT-BX50BTi.GB.3-293-640-11(1)
Note to CATV system installer:
Th is reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC that provides
guidelines for proper grounding and, in
particular, specifi es that the cable ground
shall be connected to the grounding
system of the building, as close to the point
of cable entry as practical.
The following FCC statement applies
only to the version of this model
manufactured for sale in the USA.
Other versions may not comply with
FCC technical regulations.
NOTE:
Th is equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. Th ese limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. Th is equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
 Reorient or relocate the receiving
antenna.
 Increase the separation between the
equipment and receiver.
 Connect the equipment into an outlet
on a circuit diff erent from that to which
the receiver is connected.
 Consult the dealer or an experienced
radio/TV technician for help.
CAUT
You ar
modifi
this m
operat
Th is eq
operat
antenn
Th is eq
radiati
uncon
FCC r
Guidel
Th is eq
energy
maxim
(MPE)
Th is eq
be inst
20cm a
person
hands,
Notic
Opera
two co
cause i
must a
interfe
operat
Th is eq
exposu
equipm
IC rad
Th is eq
energy
maxim
(MPE)
Th is eq
be inst
20cm a
person
hands,
CMT-