To cancel passkey entry partway
Press
.
Notes
“Passkey” may be called “Passcode, ” “PIN
code, ” “PIN number” or “Password, ” etc.
depending on the device.
Th is system only supports numerical
passkeys up to 4 digits.
Th e pairing standby status of the system is
cancelled aft er about 30 seconds.
If pairing is not successful, redo the
procedure from step 1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn off the other
Bluetooth devices.
To erase all the pairing registration
information
Press BLUETOOTH
1
on the
unit.
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
on
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
.
“Delete?” appears.
3
Press
.
“Complete!” appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones aft er
performing this operation, you must enter the
passkey again.
GB
Page 19