RHINO RLCP22 Installation Instructions

Fiat Ducato, Iveco Daily, Citroën Relay, Peugeot Boxer, Ram Promaster
Important: Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the roof racks are installed in the correct locations.
Check the contents of kit before commencing fitment and report any discrepancies.
Place these instructions in the vehicle's glove box after installation is complete.

Layout:

Care Instruction:

Maximum carrying capacity: Two cross bars; 80kg evenly distributed.
Recommendations:
It is essential that all bolt connections be checked after driving a short distance when you first install your cross bars. Bolt connec-
tions should be checked again at regular intervals (probably once a week is enough, depending on road conditions, usage, loads
and distances travelled). You should also check the cross bars each time they are re-fitted.
Make sure to fasten your load securely. Please ensure that all loads are evenly distributed and that the centre of gravity is kept as
low as possible.
Use only non-stretch fastening ropes or straps.
Sensitivity to cross winds, behaviour in curves and braking.
The handling characteristics of the vehicle, changes when you transport a load on the roof. For safety reasons, we recommend you
exercise extreme care when transporting wind-resisting loads; special consideration must be taken into account when braking.
Please remove cross bars when putting vehicle through an automatic car wash.
Load Ratings:
Maximum permissible load is 80kg for two cross bars, 100kg for three or more cross bars (include the weight of the cross bars,
5kg). When cross bars are to be used in off-road conditions, please build a safety factor of 1.5 into this load limit for off-road use,
two cross bars = 54kg, three or more cross bars = 67kg. Although the cross bars are tested and approved to AS1235-2000, Aus-
tralian road conditions can be much more rigorous. However, increasing the number of cross bars does not increase the vehicles
maximum permissible roof loading.
RLCP22 Rhino Heavy Duty Cross Bar
Wash vehicle roof especially the mounting points prior to installation.

Important Information

Three or more cross bars; 100kg evenly distributed.
System.