Bracket Adjustment; Ac Power - Martin Professional Exterior 200 User Manual

B R A C K E T A D J U S T M E N T
The mounting bracket can be positioned along the length of the power
section and pivots +70/-210 degrees from the 6 o'clock position shown
inside front cover.
This procedure requires 4 mm and 5 mm Allen wrenches (hex keys).
Warning! Allow the fixture to cool before handling.
To adjust the mounting bracket:
1 To adjust the bracket's lateral position, remove the outer discs on each side
of the bracket. Loosen, but do not remove, the bracket screws. Slide the
fixture to the desired position and retighten the bracket screws. Replace the
outer discs.
2 To adjust the tilt angle, loosen the tilt-lock screws. Turn the fixture to the
desired angle and retighten the screws.
A C P O W E R
Do not connect the Exterior 200 to an electrical dimmer system: doing so
can damage the electronics.
Warning! Disconnect the fixture from AC power before removing any
cover.
Important! Verify voltage and frequency settings before applying power.
8
tilt-lock screws
outer disc
bracket screws
Installation