LED S S S S onic onic onic onic W W W W ave ave B B B B ar ar ar ar DMX LCG-072 User Manual User User User Manual Manual Manual Please Please read read instructions instructions carefully...
Page 2
1. 1. 1. 1. SAFETY SAFETY INSTRUCTIONS: SAFETY SAFETY INSTRUCTIONS: INSTRUCTIONS: INSTRUCTIONS: • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • Unpack and check carefully there is no transportation damage before using the fixture.
Page 3
3. 3. 3. 3. TECHNICALS TECHNICALS SPECIFICATIONS TECHNICALS TECHNICALS SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS • LEDs: 12 x TRI-3W LEDs • Beam angle: 30° • LED display for easier operation • Built-in programs, sound active, auto run, M/S mode, DMX mode, static colors, IR Remote •...
Page 4
2. Press UP or DOWN button ,setup DMX address value d.001~d.512 3. Press SETUP button, enter setup DMX mode menu xxch 4. Press UP or DOWN button ,setup DMX mode 3ch, 4-c1,4c-2, 36ch, 37c1, 37c2. CHANNEL numbers numbers 3, 3, 3, 3, 4, 4, 4, 4, 4, 4, 4, 4, 36, 37,37 CHANNEL CHANNEL...
Page 5
CH15 0-255 BLUE CH16 0-255 CH17 0-255 GREEN CH18 0-255 BLUE CH19 0-255 CH20 0-255 GREEN CH21 0-255 BLUE CH22 0-255 CH23 0-255 GREEN CH24 0-255 BLUE CH25 0-255 CH26 0-255 GREEN CH27 0-255 BLUE CH28 0-255 CH29 0-255 GREEN CH30 0-255 BLUE...
CH17 0-255 GREEN CH18 0-255 BLUE CH19 0-255 CH20 0-255 GREEN CH21 0-255 BLUE CH22 0-255 CH23 0-255 GREEN CH24 0-255 BLUE CH25 0-255 CH26 0-255 GREEN CH27 0-255 BLUE CH28 0-255 CH29 0-255 GREEN CH30 0-255 BLUE CH31 0-255 CH32 0-255 GREEN...
Page 7
CH17 0-255 CH18 0-255 GREEN CH19 0-255 BLUE CH20 0-255 CH21 0-255 GREEN CH22 0-255 BLUE CH23 0-255 CH24 0-255 GREEN CH25 0-255 BLUE CH26 0-255 CH27 0-255 GREEN CH28 0-255 BLUE CH29 0-255 CH30 0-255 GREEN CH31 0-255 BLUE CH32 0-255 CH33...
Page 8
button ,you can select 7 static colors (1.-r ;2.-rg;3.-g;4.-gb;5.-b; 6.-rb ; 7.rgb; 8OFF).Press SETUP again, you can press UP or DOWN adjust the brightness of the static colors .Press SETUP button can setup the flash “FSxx” of the color .Also press UP or DOWN can adjust the speed of flash of speed.
Page 9
the “+”/“-”, adjust the correspond monochrome brightness . C C C C ) Black Black Black restore restore factory factory settings settings settings by by by by IR IR IR IR remote. remote. remote. Black out out and and restore restore factory factory settings remote.
Page 10
COMMON 1. 1 • DMX + OUTPUT • INPUT DMX - 3. 2 • Termination reduces signal errors and to avoid signal transmission problems and interference. It is always advisable to connect a DMX terminal. (resistance 120ohm 1/4W ) between pin2 (DNX-) and pin3 (DMX+) of the last fixture. 1.
Page 11
Following are a few common problems that may occur during operating. Here are some suggestions for easy troubleshooting: fixture fixture does does work, work, light light light & & & & the does does work work • The The fixture fixture does does not not work,...
Need help?
Do you have a question about the LCG-072 and is the answer not in the manual?
Questions and answers