Eaton Network Adapter FCC 15 User Manual page 19

4. To configure the slave address, type AD followed by a space and
node (1 through 247) and press [Enter]. The default is 29. This
setting affects both RS-232 and RS-485 Modbus connections.
5. To save and exit, type SA and press [Enter] to permanently save the
new configuration changes.
6. The card is now configured. Shut down the terminal emulation
program and disconnect the serial cable from the Modbus Card.
7. Continue to Chapter 5, "Integrating the UPS" on page 17.
® ®
EATON Powerware Modbus Card User's Guide
MODBUS CARD CONFIGURATION
S
164201376 Rev C www.powerware.com
15