Alfa Romeo Giulia 952 2017 Owner's Handbook Manual page 33

movement of the torso (operate the lever
until the desired position is reached, then
release it).
"SPARCO" SPORT CARBONSHELL
SEATS
(where provided)
Longitudinal adjustment
Lift lever 1 fig. 30 and push the seat
forwards or backwards.
10)
30
IMPORTANT Carry out the adjustment
while sitting on the seat involved (driver
side or passenger side).
Height adjustment
(electric)
Move button 2 fig. 30 upwards or
downwards to obtain the required height.
Backrest angle adjustment
Move lever 3 fig. 30 to adjust the
backrest angle, accompanying it with the
movement of the torso (operate the lever
until the desired position is reached, then
release it).
ELECTRICALLY ADJUSTABLE FRONT
SEATS
5)
The buttons for electrical seat
adjustment are on the outer side of the
seat, near the floor.
These buttons can be used to adjust the
height, the lengthwise position in relation
to the vehicle and the angle of the
backrest.
04066S0002EM
31
Height adjustment
Use the rear part of the switch 1
fig. 31 to modify the height and/or the
angle of the seat cushion.
Longitudinal adjustment
Push switch 1 fig. 31 forwards or
backwards to move the seat in the
corresponding direction.
Backrest angle adjustment
Push switch 2 fig. 31 forwards or
backwards to adjust the backrest in the
corresponding direction.
Electric lumbar adjustment
Use the joystick 3 to operate the lumbar
area device to obtain the right comfort
while driving.
Press the following parts of the joystick:
top: inflates the cushion;
bottom: deflates the cushion;
front: inflates the upper part of the
cushion;
rear: inflates the lower part of the
cushion.
IMPORTANT The electrical adjustment is
only allowed when the ignition device is
turned to ON and for about 2 minutes
after it is turned to STOP. The seat can
also be moved after opening/closing the
door for about 2 minutes; car
locking/unlocking or switching on of the
centre front ceiling light.
Seat angle adjustment (tilting)
04066S0003EM
(where provided)
The seat angle can be set to four
positions. Lift or push the front part of
control 1 fig. 31 to move the front part of
the seat in the corresponding direction.
Release control 1 when the seat has
reached the desired position.
31