Related Manuals for MEGASTEK GVT368
Summary of Contents for MEGASTEK GVT368
- Page 1 Vehicle Tracker _____________________________________________ User Manual V4.2.5.005 HW2.0 GVT369 GVT368...
- Page 2 Guider Quick setup…………………………………………………………………………………page >>This part helps you to know about the GVT368/369 quickly and set the GPRS function. Status of LED………………………………………………………………………………page >>According to the status of LED, we can know whether the device works well or not. Features……………………………………………………………………………………..page >>This part includes hardware and function of GVT368/369.
-
Page 3: Quick Setup
page Quick setup Interface function： Power removed detection External Power Electricity/Oil cut off (Relay) Backup battery Switch Figure 1 GPRS Setting Steps: Insert the SIM card. SIM Card Connect the GPS and GSM antenna. Install “PL2303_Prolific_DriverInstaller_v130.exe” from the provided CD on your computer. - Page 4 page Turn on the GPS device. (Turn on backup battery switch connect an external Power as figure1) （ Note: Must make sure it has enough power when you use backup battery switch ） Connect the USB cable between tracker and computer. Check the hardware info at the Control panelà...
- Page 5 page Choose the right COM port Choose the corresponding COM port according to USB-to-Serial Com Port. Click “Open” button. Press “SOS” button three times in seconds, the IMEI and version will appears at the bottom of the interface. Now you just need to set the GRPS parameters as below. IP：219.133.34.184 Port：7000 GPRS ID：100804001...
- Page 6 page Click “Apply” button and ensure write setup. It means setting successfully when the following figure appears. Disconnect the USB cable. Restart your tracker and it can work well.
- Page 7 page Status of LED LED- Power Blinking together with Orange, Blue LED Initializing / Hardware error Blinking alone Low battery Always on Charging 1s on and 3s off Normally work Blue LED- GSM Blinking together with Red, Orange LED Initializing / Hardware error SIM card is not inserted/GSM signal is not Always on received...
- Page 8 Features Hardware Satellite GPS signal GPS antenna GSM antenna Phone Vehicle GVT368/369 Server GPS module Battery GSM module 124X66X27mm Dimension: 210g Weight: 1300mAh/3.7V lithium battery (working time: up to 12 hours) Battery: ATMEGA128L MCU: SIRF-Star III GPS module: Detailed characteristic in Annex 1…..…………………………………………………page...
- Page 9 page Function Support setting 3 authorized cell phone numbers ◇ Track by demand ◇ Power saving mode ◇ SOS button for immediate rescue and alarm ◇ Geo-fencing alarm ◇ Over speed limit warning ◇ “No GPS” signal warning ◇ Motion sensor ◇...
- Page 10 page Setup by software and SMS Software 1 >>enable the corresponding function Send SMS: ② ④ 2 >>sequence number 3 >>input authorized phone number in this M000000,01,1,phone number,ABCDEFGHI blank ③ ⑤ ① A >>press SOS button for 3 seconds ① Password, default password is 000000. B >>press Help button for 3 seconds ②...
- Page 11 page Send SMS: M000000,00,AAAAAA to set a new password to be AAAAAA. Send SMS: M000000,06,A,num to set SOS and Help phone numbers. Software >>Input new password in this blank A can be 1 or 2 (6 digits, default password is 000000) 1 phone number for SOS(except GMT368)
- Page 12 page Send SMS: M000000,21,A to set GPRS function. A only can be 0 or 1 or 2 0 disable GPRS 1 enable GPRS, use TCP protocol Software 2 enable GPRS, use UDP protocol 1>>IP address of server 2>>port number of server Send SMS: 3>>Access Point Name M000000,22,ID...
- Page 13 page GeoFence Radius GeoFence’s center Software 1>>choose the sequence number of GeoFence Send SMS: 2>>input the name of GeoFence by yourself M000000,32,Offset,Name,Latitude,Longitude, 3>>input the longitude of GeoFence’s center Radius 4>>input the latitude of GeoFence’s center to set the GeoFence. 5>>input the radius of GeoFence Offset only can be 1 or 2 1 the first GeoFence >>This button is used to save data of...
- Page 14 page Annex 1: Characteristic of GPS module…………………...……………..return page GPS Characteristic Introduction Function Explain Power input DC 3.3V ±5％ GPS Chipset SIRF III GPS Frequency L1 1575.42MHz Decode C.A Code Channels 20 channels GPS Sensitivity -159 dB Cold start 37 S Warm start 35 S Hot start...
- Page 15 page Half Rate (ETS 06.20) Audio port Full Rate (ETS 06.10) Enhanced Full Rate (ETS 06.50 / 06.60 / 06.80) Operating temperature -35°C to 55 °C Storage temperature -40°C to 80 °C Humidity <95% Non-condensing Antenna Impedance : 50 Ω Annex 3: Accessories…………………………………………………..…return page 1、USB cable 2、Build-in lithium battery...
- Page 16 page Electricity/Oil Electricity/Oil passive end active end OUTx Vehicle power supply Relay Figure 2...
Need help?
Do you have a question about the GVT368 and is the answer not in the manual?
Questions and answers