Related Manuals for GYS MAGYS 261
Summary of Contents for GYS MAGYS 261
- Page 1 Mise à jour : 25/02/04 Réf 72189 INSTRUCTION MANUAL FOR SEMI-AUTOMATICAL WELDING MACHINES MAGYS 261 MAGYS 263 GENEGYS 263 SF...
-
Page 2: Electromagnetic Compatibility
GYS can’t be responsible for the damages occurred to persons or things, which derive from the use of the machine in following circumstances:... - Page 3 MAGYS 261 Terminal MAGYS 261 Protection of the line: MAGYS 261: Circuit breaker 40A curve D or fuse 40A type aM IV/ DESCRIPTION OF THE MACHINE MAGYS 261, MAGYS 263and GENEGYS 263 SF : Foreside (Higher part) Potentiometer of instructions wire speed (except on GENEGYS 263 SF).
- Page 4 Commutator 10 positions for MAGYS 263 and commutator 6 positions for MAGYS 261. Operating connector for Negative terminal. an application with a Allow to connect separated wire feeder either the main type WF.
-
Page 5: Stainless Steel
For an application with a thread « without gas », you have to connect the main clamp to the positive terminal. 5-4) Connection of the torch All torches are with a euro connection, which can be adapted on GYS machines. 5-5) Setting of rollers Choose those in function of the wire diameter used and the type of wire (See following board). - Page 6 Slump the wire in the moto wire feeder entrance. Release the clamping at maximum. Close the plate of the moto wire feeder. Press on the gate and tighten little by little the clamping handle until the motor start to drive the wire. 5-7) Brake adjustment from the coil support You must block this one in function of the weight coil used.
-
Page 7: Maintenance
Connection from a wire feeder WF to the generator Don’t forget to transpose Gas pipe the gas connection situated behind the front panel Control cable To use a wire feeder WF, tip the commutator on the Power cable position II « wire feeder WF »...