Pd Return to Factory Settings
1. To set the program to factory settings, hold the button FUNC
pressed for more than 4 seconds.
2. The display shows P1.
The unit is in the setting mode for operating 1 resp. 2 gate
openers.
3. Press FUNC several times until the display shows Pd. Hold the
button INC pressed for approx. 2 seconds in order to set the
program to factory settings. The display shows dF.
4. If all adjustments are made and in order to quit the program,
press the button FUNC. The display shows "– –". The unit
enters standby mode again.
Programming
27