P5 Blocking Force For Gate Opener 1; P6 Blocking Force For Gate Opener 2 - Westfalia 85 27 06 Instruction Manual

Attention!
 Setting the obstruction sensitivity is very important. Without a
properly adjusted safety reversal system, especially small chil-
dren or animals could be seriously injured or killed by a closing
gate.
 If the obstruction sensitively is adjusted properly, the gate will
reverse automatically as soon as the gate comes into contact
with an obstruction. Based on the length and the weight of the
gate it may be necessary to make force adjustments. The force
adjustment should be high enough so that small objects, such as
branches or strong winds will not disturb the function, but low
enough to prevent serious injury to persons or damages to
vehicles.
 Too much force on the gate will interfere with the proper
operation of the safety reversal system. Do not increase the
force beyond the minimum amount that will be required to close
the gate. When making new adjustments, the gate must be
checked for proper function. Please also check the reversion
(See page 31).
 You may need to increase the blocking force in cold weather due
to increased resistance from the gate hinges.

P5 Blocking Force for Gate Opener 1

1. Press the button INC or DEC.
Factory setting = level 3. Settings from 1 – 9 are possible.
2. For storing press FUNC.
The display shows P6. The unit is in the mode "Blocking Force
for gate opener 2"

P6 Blocking Force for Gate Opener 2

1. Press INC or DEC.
Factory setting = level 3. Settings from 1 – 9 are possible.
2. For storing press FUNC.
Programming
23