Westfalia 85 27 06 Instruction Manual page 20

Mark the drilling holes through the gate
bracket and drill holes with 10 mm diameter
into the gate. Tighten all screws and nuts.
Protruding bolt ends (10) should be cut with
the hacksaw.
Cover the gate opener while drilling. Please
note that dust and swarf might damage the
gate opener.
Use the included screws or other suitable
screws and dowels for the resp. surface.
If the braces of the gate are thin, the
braces can be reinforced with sturdy metal tubes. By doing this, the
gate bracket (8) can be mounted securely on the braces. A wooden
or metal plate can also be screwed on the gate.
Braces
Sturdy Metal Tube
Gate is OPENED
Mounting
8
Braces
16
Drill Holes
Bracket Assy
Wood/
Metal
10 mm Holes