Table of Contents
Advertisement
TOOLS REQUIRED
• Tinsnips to cut banding
• Stepladder
• Bucket
• Level
• Appliance dolly
• Tubing cutter
• 7/16" open-end wrench
• #2 Phillips screwdriver
• Drill and appropriate bits
• 5/16", 7/16" socket
• Safety glasses
• 1-1/4" and 1/2" open-ended wrench
• Pliers
• 1/4" ratchet or 1/4" angled wrench
HARDWARE SUPPLIED
• Water filter bypass plug
• Anti-Tip brackets
• 1/4" nut and ferrule
TRIM SUPPLIED
A. Soffit vent top
B. Left inside case trim
C. Right inside case trim
D. Center U-shape trim
E. Grille base wrap
F. Grille panel
G. Toekick
H. Foam spacer pads
I. Phillips screws
GROUNDING THE REFRIGERATOR
IMPORTANT—(Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a 3-prong (grounding) plug which mates with a
standard three-prong (grounding) wall receptacle
to minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
Installation Instructions
C
D
E
F
G
H
I
6
MATERIALS REQUIRED
• 71" long 2x4 for Anti-Tip support
• 1/4" copper water line tubing or two GE
SmartConnect
™
Refrigerator Tubing kits
• Two water shut-off valves
• Screws to secure refrigerator to cabinetry
• Stick-on hook and loop fastener strips for 1/4"
side panels
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should be
strong enough to support a fully loaded refrigerator, or
approximately 2,400 lbs.
NOTE: Protect the finish of the flooring. Cut a large section
of the cardboard carton and place under the refrigerator
where you are working.
A
B
Where a standard 2-prong wall outlet is encountered,
it is your personal responsibility and obligation to
have it replaced with a properly grounded 3-prong
wall outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE
REFRIGERATOR TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
Advertisement
Table of Contents
