Instruction Book
Page 57
Effective: May 2006
4-2 DRAWOUT CIRCUIT BREAKER DIMENSIONS
The Magnum drawout circuit breaker connects to the fixed
primary stabs of the drawout cassette through the primary
finger clusters attached to the rear of the circuit breaker.
Three different frame sizes cover all Magnum circuit break-
ers from an overall dimensional standpoint. Circuit breaker
drawings can be found in Engineering Data
TD01301004E.
Figure 4-4 Typical MDS Narrow Frame Cassette
(Horizontal Terminals)
Figure 4-6 Typical MDS/MDSX Basic Cassette (Without
Stabs) (Shown with MDS Type Arc Hood)
Figure 4-5 Typical MDS /MDSXStandard Cassette
(Vertical Terminals) (Shown with MDS Type Arc Hood)
MDS Arc Hood
For more information visit: www.EatonElectrical.com
4-3 DRAWOUT CASSETTE DIMENSIONS
Cassette drawings provide all the dimensional informa-
tion required for all mounting configurations and can
also be found in Engineering Data TD01301004E.
Review carefully for a specific installation.
Figure 4-7 Typical MDS/MDSXUniversal Cassette, 4-Pole
(Flat Terminal Pads) (Shown with MDS Type Arc Hood)
MDS Arc Hood
MDS Arc Hood
I.B. 2C12060H08