Table of Contents
Advertisement
3e-531AP Wireless Access Point
WAN
Next, click the entry on the left hand navigation panel for System
Configuration -WAN. You will be directed to the System Configuration
– WAN page.
This screen allows you to set Link Speed and Duplex of the WAN
port. If you select a choice other than Auto (the default), the 3e-531AP
will use only the selected link speed (10 Mbits/sec or 100 Mbits/sec) and
Duplex (Half Duplex transfers or Full Duplex transfers) that you select in
the WAN/LAN Link dropdown menu.
If not using DHCP to get an IP address, input the information that the
access point requires in order to allow the wireless devices it controls ac-
cess to the wired LAN. This will be the IP address, Subnet Mask, Default
Gateway, and, where needed, DNS 1 and 2.
Click Apply to accept changes.
29000125-001 C
Chapter 3: Access Point Configuration
17
Advertisement
Table of Contents
