Table of Contents
Advertisement
3e-531AP Wireless Access Point
In the second section on the Wireless Configuration — Bridging
screen, add the BSSID of the remote bridge. The BSSID corresponds to
that bridge's MAC address. In entering the BSSID, enter only hexadecimal
numbers, no colons. Data entry is not case sensitive. You may also enter
a note that defines the location of the remote bridge. Then click Add to
accept. The remote bridge's BSSID will now appear in the third section of
the page. If, at some time, you wish to delete the entry, simply click the
check box next to it and confirm by clicking Delete.
Next, navigate to Wireless Configuration — Bridging Encryption.
Select the appropriate key type and length and the key value. The encryp-
tion key value and type for Bridge 1 must be the same as for Bridge 2.
You must complete the configuration of your Bridge 1 by visiting the
other screens included in the navigation bar and following the general
instructions in Chapter 3 of this guide to establish any other required con-
figuration options such as General, WAN and LAN settings.
Configure the second of your two point-to-point bridges following the
instructions given for Bridge 1 above.
74
Chapter 5: Bridge Configuration
29000125-001 C
Advertisement
Table of Contents
