Table of Contents
Advertisement
2.2.2 Rear
1
7
1
7
(1) Power switch
(2) 75Ω DIP switch
These switches are used to terminate the video input signal and
are used when CCTV cameras are simultaneously connected to
both the Brans200 and other video equipment (CCTV monitor,
etc,). In that case, just carry out termination on either of two
imaging devices. Termination of Brans200 is basically set 'ON' at
the time of shipment from the factory.
(3) Sensor Input connector (Dl)
This connects up to four (4) dry contact input sensors, etc. to
Brans200. Each port is composed of 2 contacted connectors,
sensor input on the left side and ground on the right side.
(4) Data Output (DO) connector
It enables you to connect alarm lights, alarms, door cutoffs and
lighting system, up to 4 ports. Left side of each port is Output
connector contact point and right side is ground contact point.
(5) Data Output type selection switch
It allows you to select Output type of alarm connected to
Brans200. Check if desired alarm is normally open (NC) or
normally closed (NO) type for setting. You must set type of sensor
input on Admin page.
(6) Video Input Connectors
Connect up to 4 cameras to the BNC connectors. The server recognizes camera
signal type (NTSC or PAL) automatically.
Brans200/200E rev. 1A
2
3
8
9
10
Brans 200
9
3
10
4
5
Brans 200E
4
6
11 12 13
8
12 11
- 9 -
5
6
Jan 2003
Advertisement
Table of Contents
