SparePartsAndOptions; Mmc(Multi-Media-Card)MemoryCard - Jesco TOPAX DX Operation & Maintenance Instructions Manual

Chapter20/21:Sparepartsandoptions/MemoryCard

20.Sparepartsandoptions

Components,options,sparepartsandfunction
Output board 5 relays, 3 optocoupler
input board free chlorine (CS10 or encapsulated
5-fold electrode), pH-value, Redox, temperature,
position feedback servo motor, controller 1
input board 3 free chlorine (potentiostat), 0/4...0 mA,
fold position feedback, servo motor controller 
Interface module RS 485
Extension module for metering of total chlorine content and
controlling of bonded chlorine
Extension module for metering and controlling of the conduc-
tivity
Srew M4 x 6 (tool to open the casing)
Hinge pivot
fixing hing pivot at the top
fixing hing pivot below
MMC (Multi-Media-Card) memory card
50 | Operation Manual TOPAX DX | BA-40100
21.Memorycard
The memory card transfers and stores language data, firmware-
Orderno.
updates and logfiles.
The data which is saved on the card can be transferred to a PC
78399
by means of a reading device. For the removal of the MMC card,
78403
the TOPAX
®
Off" key in the "service-reset" menu. All controllers are set to an
output capacity of "0%" and all unsaved data is saved on the
78404
MMC card. The TOPAX
card.
78406
78438
78439
38341
38336
38337
38338
Fig. .1: Slot for the MMC Memory card on the display board. The card is
78405
inserted on the display circuit board in the front housing.
NOTICE!
The memory card must only be inserted or removed
when the device is voltage-free. Switch off the
TOPAX DX on the "service-reset" menu (see chapter
16, menu 5.4).
On its website, the manufacturer provides the free software
"TopReader" for the readout of the MMC with the recorder and
configuration data.
NOTICE!
Make sure that no additional data is saved on the MMC and that
the saved data are not modified (data loss). The MMC must only
be formatted in "FAT" format.
DX must be switched off definedly: press the "Switch
DX can continue to operate without the
®