The Washing Results And Drying Results Are Not Satisfactory - AEG FAVORIT 77000 User Manual

20
What to do if...
Malfunction
The appliance does
not fill with water
The appliance does
not drain the water
The anti-flood device
operates
The program does
not start
After the check, switch on the appliance. The program continues from the point of inter-
ruption. If the malfunction occurs again, contact your Customer Care Centre.
If the display shows an alarm code, not described in the chart, contact your Customer Care
Centre.
When you contact the Customer Care Centre you will need to give some details of the ap-
pliance that can be found on the rating plate (e.g. model number, serial number, product
number). We recommend that you record these details.

The washing results and drying results are not satisfactory

Problem
The dishes are not clean.
Possible cause
The water tap is closed.
The filter in the water inlet hose is
blocked.
The installation of the water inlet
hose is not correct. The hose is bent
or squashed.
The water tap is blocked or restricted
with limescale.
The water pressure is too low.
There is a blockage in the sink spi-
got.
The installation of the water drain
hose is not correct. The hose is bent
or squashed.
The appliance door is not closed. The
door indicator is on.
The Start button or touchpad has
not been pressed.
Mains plug is not connected.
The delay start is set.
The fuse has blown out in the
household fuse box
Possible cause
The selected washing program
was not suitable for the type of
load and soil.
Possible solution
Open the water tap.
Clean the filter.
Make sure that the installation is
correct.
Clean the water tap.
Contact your local water authority.
Clean the sink spigot.
Make sure that the installation is
correct.
Close the water tap and contact
your Customer Care Centre.
Close the door.
Press the Start button or touchpad.
Plug-in the appliance to the mains.
• Cancel the delay start.
• Wait until the countdown of the
delay start is completed.
Replace the fuse.
Possible solution
Make sure that the washing
program is suitable for the type
of load and soil.