The Washing Results And Drying Results Are Not Satisfactory - AEG FAVORIT 55002 VI User Manual

20
What to do if...
Malfunction
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................

The washing results and drying results are not satisfactory

Problem
The dishes are not clean.
Limescale particles on the
dishes.
Possible cause
The mains plug is not connec-
ted in the mains socket.
The fuse in the fuse box is dam-
aged.
The delay start is set.
Possible cause
The washing programme was
not applicable for the type of
load and soil.
You did not put the items cor-
rectly in the baskets, water did
not touch all surfaces.
The spray arms could not turn
freely. Incorrect position of
the items in the baskets.
The filters are dirty or not as-
sembled and installed correct-
ly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect level of the water
softener adjustment.
The salt container cap is not
closed correctly.
Possible solution
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatical-
ly.
Possible solution
Make sure that the washing
programme is applicable for
the type of load and soil.
Put the items correctly in the
baskets.
Make sure that an incorrect po-
sition of the items do not
cause the blockage of the
spray arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener with
the correct level.
Make sure that the salt con-
tainer cap is closed correctly.