Device Settings - dji Thumb Controller User Manual

When the "Reverse" orientation is selected, the up/down and left/
right controls are switched.
Calibration
"Cali System" should be used if there is perceptible drift on any
axis. The calibration procedure should take approximately 90
seconds to complete.
Selecting "Auto Tune" will automatically adjustment each motor's
stiffness settings to achieve an optimal balance. This process
should take approximately 20 seconds to complete.
The gimbal cannot be controlled by the Thumb Controller or the
remote controller during calibration. Do not touch or move the
gimbal during either process.

Device Settings

Sensitivity
There are two sensitivity settings for the Thumb Controller: Soft/Hard.
Sleep
If the Thumb Controller has been idle for longer than the specified
amount of time, the OLED display will be turned off.
Power Off
If the Thumb Controller has been idle for longer than the specified
amount of time, it will be turned off.
Default Settings
Restores all settings to the factory defaults.
About
Displays the firmware version that is currently installed on the
Thumb Controller.
©
2015 DJI. All Rights Reserved.
15