Canon imagePROGRAF TX-2000 Introductory Information page 6

3
Peel off the tape affixed to the carriage, and then pull the protective
material (A) towards you and remove it. Remove the protective sheet
if there is one attached.
5
Plug the power cord into the power supply connector on the back of the printer.
TX-2000 / TX-3000
6
Plug the power cord into the outlet.
8
When the language selection screen appears on the touch screen,
select and tap a language (lightly with your finger, and then move
your finger away). Then, if the screen for selecting a time zone
appears, select and tap your region.
A
6
4
Close the top cover.
TX-4000
7
Turn on the printer.
9
When a message prompting you to start the setup appears on the
touch screen, tap OK.