Assemble The Stand; Install The Printer - Canon imagePROGRAF TX-2000 Introductory Information

Assemble the Stand

• When using the stand
-> Assemble the stand on which you will install the printer by referring to the
• When not using the stand

"Install the Printer"

-> Proceed to
Attach the Alignment Rod
1
Attach the rod for aligning the printer to the stand.
When using the basket included with the stand
1. Prepare the basket rod (cord side).
2. Hook the basket rod onto the supporting plates of the stand legs.
Attach such that the protrusions (A) on the basket rod are facing
towards you.
A
Install the Printer
1
Remove the packaging material.
.
Printer Stand Setup Guide (separate manual)
When using the stacker
1. Open the stacker box and take out rod 2.
2. Hook rod 2 onto the supporting plates of the stand legs. Attach
such that the holes (A) on rod 2 are facing up.
2
Remove all of the tape and other packaging material. Open the top
cover (A) and output guide (B), and then remove the tape affixed to
the roll holder.
3
.
A
A
A
B