Getting Started; Batteries; Access Front Button Panel; Change Settings - Oregon Scientific BAR608HA User Manual

GETTING STARTED

BATTERIES

Batteries are not supplied with this product. You will need
to purchase 3 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
shows when batteries are low.
UNIT LOCATION
Main Indoor Temperature /
Humidity Area
Remote Outdoor Temperature /
Humidity Area

ACCESS FRONT BUTTON PANEL

The front button panel is located inside the right portion
of the main unit. Slide it right to access the buttons.
7
BAR608HA_EN_R0C.p65

CHANGE SETTINGS

1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press or to change settings.
3. Press MODE to confirm.
TABLE STAND OR WALL MOUNT
Use the stand on the back of the product, or mount it on
a wall with a nail.

REMOTE SENSOR (THGR268)

This product is shipped with a THGR268 Thermo-Hygro
Sensor that collects temperature and humidity
can be collected from up to 3 sensors. Additional sensors
sold separately.
6
6/29/04, 4:52 PM
data. Data