OSO DGC 200 Installation Manual page 14

INSTALLER & COMMISSIONING ENGINEER DETAILS
COMPANY NAME
ADDRESS
INSTALLER NAME
REGISTRATION DETAILS
REGISTERED OPERATIVE ID CARD No.
(IF APPLICABLE)
COMMISSIONING ENGINEER (IF DIFFERENT)
NAME
ADDRESS
TEL No.
REGISTRATION DETAILS
REGISTERED OPERATIVE ID CARD No.
(IF APPLICABLE)
GUARANTEE - OSO UNVENTED HOTWATER CYLINDER
The OSO stainless steel inner vessel is guaranteed against material defect or manufacturing faults for a period of 25 years from the
date of purchase. All other parts including, but not limited to factory fitted electrical elements (damage caused by lime scale excluded),
expansion vessel, thermostats and valves are guaranteed against material defects or manufacturing faults for 2 years from the date
of purchase. In the event of a replacement component being required OSO Hotwater will supply such part(s) free of charge and
freight paid, on condition that the defective component is delivered, freight paid to OSO Hotwater within 2 weeks of written notice
being given to OSO Hotwater of the defect. Such replacement parts shall be guaranteed under the terms of this guarantee to the
unexpired period of the aforementioned 2 year period.
This warranty is conditional upon the OSO cylinder being installed in compliance with the OSO Installation & Maintenace Instructions, all
current legislation, codes of practice and regulations governing the installation of unvented hot water cylinders in force at the date of instal-
lation and provided that:
1. The water quality shall be in accordance with European Council Directive 98/83 EC, or revised version at the date of installation,
and is not fed with water from a private supply.
Particular: Chloride content:
Sulphate content:
Combination Chloride/sulphate:
2. The OSO cylinder is filled with water before turning the electricity supply on to the heater elements.
3. The log book certificate is completed at the time of installation.
4. The OSO cylinder is serviced and maintained every 12 months and is marked as such in the logbook provided with the cylinder.
Invoices for the maintenance work should be kept as proof of regular maintenance. Care should be taken of the logbook and
invoices as they serve as the guarantee certificate for the cylinder.
5. If the newly fitted water heater is not in regular use then it must be flushed through with fresh water for at least 15 minutes Open
at least one hot water tap once per week, during a period of at least 4 weeks.
6. The OSO unvented cylinder has not been modified in any way other than by OSO Hotwater and is only used for the storage of
potable water.
7. No factory fitted parts have been removed for unauthorised repair or replacement.
8. Defects caused by frost, excess pressure, salt dehardner process, transient voltage, lightning strikes or incorrect installation,
repair or use, are not covered by this warranty. A laboratory evaluation of possible defects can be ordered by the user, however
the user must pay for this where the above mentioned conditions have not been fulfilled. Evidence of the purchase date and the
date of supply must also be submitted with your claim.
This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss
or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.
IT IS THE RESPONSIBILITY OF THE INSTALLER TO COMPLETE THIS LOGBOOK AND PASS IT
ON TO THE CUSTOMER. FAILURE TO DO SO MAY INVALIDATE THE CYLINDER GUARANTEE
INSTALLER DETAILS
Max. 250 mg/l
Max. 250 mg/l
Max. 300 mg/l (in total)
DATE
TEL No.
DATE
14