Table of Contents
Advertisement
Quick Links
CONTACTS
- DRAPER TOOLS LIMITED,
Hursley Road, Chandler's Ford,
Eastleigh, Hampshire. SO53 1YF . U.K.
- Helpline: (023) 8049 4344
- Sales Desk: (023) 8049 4333
- General Enquiries: (023) 8026 6355
- Service/Warranty Repair Agent
For aftersales servicing or warranty repairs, please
contact the Draper Tools Helpline for details of an
agent in your local area.
YOUR DRAPER STOCKIST
DBDH1016
drapertools.com
Advertisement
Table of Contents
Related Manuals for Draper Gen 2 Master Kit
Summary of Contents for Draper Gen 2 Master Kit
- Page 1 - Sales Desk: (023) 8049 4333 - General Enquiries: (023) 8026 6355 - Service/Warranty Repair Agent For aftersales servicing or warranty repairs, please contact the Draper Tools Helpline for details of an agent in your local area. YOUR DRAPER STOCKIST DBDH1016...
-
Page 2: General Information
AlI photographs and drawings in this manual are supplied by Draper Tools to help illustrate the operation of the product. - Page 3 PREPARING THE GEN 2 MASTER KIT 1.1 INTRODUCTION This Front Hub Wheel tool is designed to remove the front bearing housing from the drive flange without the need of a press. • APPLICATION: 62mm - Audi A2, VW Lupo(front). 66mm - Skoda Fabia, VW Fox(front), VW Polo.
- Page 4 NOTES...
- Page 5 SETTING THE 82mm FITTING/REMOVAL TOOL NOTE: Grease the screw threads before FIG. 5 using this tool. Before using this tool ensure that the ABS sensor has been removed. WARNING: Do not use impact tools when removing. 5.1 REMOVING THE BEARING Select a 4 long pin configuration.
- Page 6 TECHNICAL DESCRIPTION 2.1 IDENTIFICATION Install adaptor. Removal adaptor. Removal adaptor. Install adaptor. Removal adaptor. Pressure plate. Pressure plate. Pressure plate. Adaptor. Adaptor. Adaptor. Adaptor. 62mm install plates. 62mm removal plates. Pin. Pin. Pin. Pin. Pin. Pin. Pin. Pin. Pin. 85mm removal plates. 72mm install plates.
- Page 7 Ensure you are using the correct pin configuration. Follow vehicle or bearing manufacturer’s fitting guidelines. Draper Tools will not be responsible for damage caused by the incorrect use of this tool. 3.1 REMOVING THE BEARING Select 4 or 5 pin configuration.
- Page 8 SETTING THE 78mm FITTING/REMOVAL TOOL NOTE: Grease the screw threads before FIG. 3 using this tool. Before using this tool ensure that the ABS sensor has been removed. WARNING: Do not use powered or manual impact tools when removing. 4.1 REMOVING THE BEARING Select 4 pin configuration.
Need help?
Do you have a question about the Gen 2 Master Kit and is the answer not in the manual?
Questions and answers