Operating Procedures And Maintenance; Unpacking Your Ice Maker; Connecting Your Ice Maker; Using Your Ice Maker - NewAir AI-250W Owner's Manual

OPERATING PROCEDURES AND MAINTENANCE

UNPACKING YOUR ICE MAKER

1. Remove all exterior and interior packaging. Make sure that the ice basket and
ice scoop are included. If any part or accessory is missing, please contact our
customer service department.
2. Clean the interior with lukewarm water and a soft cloth. Remove the ice basket
and wash it in warm water.
3. Clean the evaporator rods using a water/vinegar solution.
4. Find a location for your ice maker that is protected from direct sunlight and you
will need six inches of space between the back and sides of your ice maker and
the wall.

CONNECTING YOUR ICE MAKER

Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, please call our customer service
department.
1. This unit should be properly grounded for your safety.
2. Plug the appliance directly into an appropriate 120V AC outlet that is properly
installed and grounded in accordance with all local codes and ordinances.

USING YOUR ICE MAKER

1. Press the "ON/OFF" button after plugging in the ice maker machine and it will
begin to run. Tip: You can use drinking water.
2. Open the cover, remove the ice basket and pour water into the tank, make sure it
does not surpass the maximum water level. Put the ice basket back into the
machine and close the lid. Tip: Keep the water below the ice basket.
3. While the ice maker is on, check the water level periodically. If the water pump
cannot inject water, the ice maker will stop automatically and the "WATER"
indicator will be on. Press the "ON/OFF" button, fill water up to the level mark
and press the "ON/OFF" button again.
8
http://www.NewAir.com