Table of Contents
Advertisement
Note
Run from Target
System Reset
Note
3-12 In-Circuit Emulation
You have to use HP 64784-66509 when you emulate H8/3001 with
mode 3/4 or H8/3004/05 with mode 3.
You can use "r rst" command to execute program from target system
reset. You will see T> system prompt when you enter "r rst". In this
status, the emulator accept target system reset. Then program starts if
reset signal from target system is released.
In the "Awaiting target reset" status(T>), you can not break into the
monitor. If you enter "r rst" in out-of-circuit or in the configuration that
emulator does not accept target system reset (cf trst=dis), you must
reset the emulator.
Advertisement
Table of Contents
