Table of Contents
Advertisement
# remaining number of terms
# remaining emulation memory
map 0000000..000ffff
map
other tram
Note
Note
Transfer Code
into Emulation
Memory
Transferring Code
from a Terminal In
Standalone
Configuration
R> m 002000..00200f=54,48,49,53,20,49,53,20,4d,45,53,53,41,47,45,20
R> m 002010..00201f=41,54,48,49,53,20,49,53,20,4d,45,53,53,41,47,45
2-12 Getting Started
You will see:
: 15
: 6e800h bytes
erom
# term 1
You must map internal ROM as emulation memory.
You don't have to map internal RAM, since the emulator maps internal
RAM as emulation RAM. And the emulator memory system dose not
introduce it in memory mapping display.
Refer to "Memory Mapping" section of "Configuring the Emulator"
chapter in this manual for more details.
To transfer code into emulation memory from a data terminal running
in standalone mode, you must use the modify memory commands.
This is necessary because you have no host computer transfer facilities
to automatically download the code for you (as if you would if you
were using the transparent configuration or the remote configuration.)
To minimize the effects of typing errors, you will modify only one row
of memory at a time in this example. Do the following:
1. Enter the data information for the program by typing the
following commands:
Advertisement
Table of Contents
