Table of Contents
Advertisement
Familiarize
Yourself with the
System Prompts
Note
The following steps are not intended to be complete explanations of
each command; the information is only provided to give you some idea
of the meanings of the various command prompts you may see and
reasons why the prompt changes as you execute various commands.
You should gain some familiarity with the HP 64700 emulator
command prompts by doing the following:
1. Ignore the current command prompt. Type:
*> rst
You will see:
R>
The rst command resets the emulation processor and holds it
in the reset state. The "R>" prompt indicates that the
processor is reset.
2. Type:
R> r 1000
You will see:
U>
The r command runs the processor from address 1000 hex.
3. Type:
U> b
You will see:
M>
The b command causes the emulation processor to "break"
execution of whatever it was doing and begin executing within
Getting Started 2-19
Advertisement
Table of Contents
