Table of Contents
Advertisement
Note
Running the
Sample Program
Note
reg pc=001014 ccr=84 er0=00000000 er1=000ff800 er2=00000000 er3=00000000
reg er4=00000000 er5=00000000 er6=00000000 er7=000ff904 sp=000ff904 mdcr=c7
2-20 Getting Started
the emulation monitor. The "M>" prompt indicates that the
emulator is running in the monitor.
If DMA transfer is in progress with BURST transfer mode, b command
is suspended and occurs after DMA transfer is completed.
4. Type:
M> r 1000
The emulator changes state from background to foreground
and begins running the sample program from location 1000
hex.
The default number base for address and data values within HP 64700
is hexadecimal. Other number bases may be specified. Refer to the
Tutorials chapter of this manual or the HP 64700 User's Reference
manual for further details.
5. Let's look at the registers to verify that the address registers
were properly initialized with the pointers to the input and
output areas. Type:
U> reg
You will see:
Notice that ER1 contains 0ff800 hex.
Advertisement
Table of Contents
