John Lewis JLBIFIC02 Instruction Manual page 10

From the plastic cover (E), which is used to cover
the hinge with the pivot pin, you must take away the
part as indicated in the drawing.
This operation is made easer since there is, in the
internal part of the cover hinge lid a groove that
facilates the removal of this coomponent.
"Remove the part marked with DX, if the pivot pin
is inserted in the right hinge, SX in opposite case."
Apply covers (C-D) on joint cover lugs and into
hinge holes.
Snap vent grille (B) and hinge covers (E) into
position.
Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes.After having drilled
holes, fix the guide with the screws supplied.
Fix cover (Hc) on guide (Ha) until it clips into place
10
C
D
E
E
B
Ha
Hb
Hc
Hd
PR266
ca. 50 mm
90°
ca. 50 mm
Ha
Hc
PR33