Installing The Holster; Adjusting The Harness - Makita DUP361 Instruction Manual

Installing the holster

2
1
► 1 . Holster 2. Strap
Pass the belt of the lower buckle through the opening of
the holster.

Adjusting the harness

Adjust the harness as follows:
1. Close and lock the lower buckle, and adjust its belt
length.
1
► 1 . Lower buckle
2. Adjust the shoulder strap length.
3. Adjust the position of the upper buckle. Close and
lock the upper buckle and adjust its belt length.
► 1 . Upper buckle
CAUTION:
In case of emergency, quickly
open the lower buckle and upper buckle, loosen
shoulder straps, and set down the backpack.
Installing the connection cord
CAUTION:
Always make sure that the switch
box's I/O switch is on the "O" side before attach-
ing the connection cord.
CAUTION:
Do not operate the tool if the con-
nection cord is damaged.
NOTICE:
Do not abuse the connection cord. Do not
carry the tool by pulling the connection cord. Keep the
connection cord away from heat, oil, or sharp edges.
Otherwise the connection cord may be damaged.
Attach the connection cord with the switch box and the
shears as follows:
1. First, align the triangular marks of the male plug
of the connection cord with the triangular mark of the
female connector of the switch box. Push in the plug of
the connection cord to the connector of the switch box.
Then, align the marking on the coupling with the trian-
glar marks, and push in and turn the coupling to tighten.
9 ENGLISH
1