5. First fit the valve onto the right-hand bolt in the saddle.
6. Fit and then tighten the two bolts on the left-hand side. Tighten the bolt
on the right.
7. Fit the hose from the drum on the valve. Use the rubber edge on the
hose and pull down the hose over the valve cover. Check that the hose
edge snaps into place over the lower edge of the cover.
8. Test the machine by running a program and check valve functioning and
that the machine is not leaking.
9. Fit the trim panel, door and front panel. Lock the screws for the door and
trim panel with locking fluid (Loctite no. 243).
Drain valve
83
438 9047-91/01