Install The Front Bezel; Hard Drives - Dell SC7020 Owner's Manual

Figure 6. Installing and Removing the Bezel
1. Keylock

Install the Front Bezel

To secure the storage system, install the front bezel.
1. Hook the right end of the replacement bezel onto the front panel of the storage system.
2. Insert the left end of the bezel into the securing slot until the release latch locks into place.
3. Secure the bezel with the keylock.

Hard Drives

The SC7020 series storage system supports hot-swappable hard drives.
• In the SC7020 storage system, a minimum of 4 SSDs or 7 drives must be installed in the chassis or in an expansion enclosure.
• In the SC7020F storage system, a minimum of 4 SSDs must be installed in the chassis or in an expansion enclosure.
The drives are installed from left to right, and then top to bottom. The first row of drives are numbered from 0–4 from left to right,
the second row of drives are numbered from 5–9 from left to right, and so on.
Storage Manager identifies drives as XX-YY, where XX is the number of the unit ID of the storage system and YY is the drive
position inside the storage system.
Figure 7. SC7020 Series Storage System Drive Numbering
12
Replacing SC7020 Series Storage System Components
2. Front bezel