Setting-Up The System; Functional Test; Switch On - Raymarine EV-100 Installation Instructions Manual

Setting-up the system

Functional test

Switch on

When you have installed the system, you need to check that the
system is wired correctly and set up to suit your type of boat.
This chapter provide instructions for the following post-installation
procedures:
1. When you have installed your autopilot system, switch
on the main power breaker.
2. If the control unit is active and the system operating, the control
unit will beep and display the pilot type (Wheel or Tiller).
CAUTION: Wheel drive systems
One second after power-on the wheel pilot will drive to starboard
for three seconds. This is to allow even wear on the drive belt.
3. After displaying the pilot type for two seconds, the control unit
will then display the Standby screen.
23