Setting Up The Zeno 20 With A Disto S910 - Leica Zeno 20 User Manual

4.6
GAMtec-Setup
Zeno 20 Android, Operation

Setting up the Zeno 20 with a Disto S910

You can combine the Zeno 20 with a Disto S910 to get a TPS-similar setup.
Position the setup close to the asset where the GNSS conditions are good and
measure your target with the Disto S910. This method allows you to measure inacces-
sible or unreachable points from a safe distance and to collect data in areas where the
GNSS reception is bad. To increase your productivity, it is also possible to measure
multiple assets within sight of one setup point.
009345_001

For more information on how to use the Zeno 20 with a Disto S910, refer to
the respective software documentations.
Accuracy of Measured Points
When using the combination of Zeno 20 and Disto S910, the accuracies of the points
measured with the Disto S910 depend on different variables. To ensure high point
accuracies, keep in mind the following principles:
1) The farther away the reference point that you measure for your orientation, the
better the resulting point accuracies. Make sure that the reference point is at least
25 m away from your current position.
2) When measuring new points with the Disto S910 that are far from your current
position, the point accuracy decreases.
3) The better the accuracy of the reference point and of the current position, the
better the resulting point accuracies. When measuring points with GNSS, make sure
that you measure with highest possible accuracy, for example with open sky condi-
tions and averaging of at least 10 seconds.
Tripod Solution:Zeno 20 and Disto S910 are
mounted on a tripod using the Disto FTA360
adapter. This solution allows for a stable setup
for more accurate measurements with the
Disto S910. For this setup, you can use the
internal antenna of the Zeno 20.
28