Pad Modes - Denon SC5000 Prime User Manual

Pad Modes

The 8 pads and Parameter / buttons have different functions in each pad mode.
To enter each pad mode, press the corresponding button: Hot Cue, Loop, Roll, or Slicer.
Hot Cue Mode
In Hot Cue Mode, you can use each pad to jump to an assigned hot cue point.
To assign a hot cue to a pad, press an unlit pad at the desired location in the track. The pad will light up when a hot cue
point is assigned.
To jump to a hot cue point, press the corresponding pad.
Tip: You can use the Engine Prime software to name your hot cue points, and the names will appear in the display for
reference.
To clear a hot cue from a pad, press Shift and the desired pad. The pad will turn off when there is no hot cue point
assigned to it.
Loop Mode
Loop 1
In Loop Mode, you can use each pad to activate an assigned loop.
To assign a loop to a pad, press an unlit pad while in the active loop. The pad will light up when a loop point is assigned.
To trigger a loop, press the corresponding pad.
To retrigger a loop, press Shift and the desired pad.
To shift the loop left or right, use the Parameter / buttons.
To create a 4-beat or 8-beat auto loop, press Shift and the Parameter  or Parameter  button, respectively.
Roll Mode
1/8-Beat
In Roll Mode, you can press and hold each pad to trigger a "loop roll" of a certain length while the track's timeline
continues (the lower half of the waveform in the display will continue moving forward). When you release the pad, the
track will resume normal playback from where it would have been if you had never done anything (i.e., as if the track had
been playing forward the whole time).
To trigger a roll, press the corresponding pad.
Hot Hot
Cue 1 Cue 2
Loop 2
1/4-Beat
Roll Roll
Hot Hot
Cue 3 Cue 4
Loop 3 Loop 4
1/2-Beat 1-Beat
Roll Roll
Hot Hot
Cue 5 Cue 6
Loop 5 Loop 6
2-Beat 4-Beat
Roll Roll
Hot Hot
Cue 7 Cue 8
Loop 7 Loop 8
8-Beat 16-Beat
Roll Roll
13