Cleaning Reminder; Cleaning The Oven Door - Zanussi ZZP37901XX User Manual

Pull the front of the
1
shelf support away
from the side wall.
Install the shelf supports in the opposite
sequence.
Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if you did
not fully close the oven door. In
some models, the display shows
"C3" when this error occurs.
WARNING!
The appliance becomes very hot.
There is a risk of burns.
CAUTION!
If there are other appliances installed
in the same cabinet, do not use
them at the same time as the
Pyrolysis function. It can cause
damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn from
the hot air.
3. Set the Pyrolysis function. Refer to "Oven
functions".
flashes.
4. You can use the End function to delay the
start of the cleaning procedure.
5. Press or turn the knob for the
temperature clockwise to start the cleaning
procedure.
Time of the procedure: 2 h.
During the Pyrolysis the oven lamp is off.
When the oven is at its set temperature, the
door locks. The display shows the symbol
18
1
2
Pull the rear end of
2
the shelf support
away from the side
wall and remove it.
and the bars of the heat indicator until the door
unlocks.

Cleaning reminder

To remind you that the Pyrolysis is necessary,
PYR flashes in the display for 10 seconds after
each activation and deactivation of the
appliance.
The cleaning reminder goes out:
• after the end of the Pyrolysis
function.
• if you press
same time while PYR flashes in
the display.

Cleaning the oven door

The oven door has four glass panels. You can
remove the oven door and the internal glass
panels to clean them.
The oven door can close if you try to
remove the glass panels before you
remove the oven door.
CAUTION!
Do not use the appliance without the
glass panels.
Open the door fully
1
and hold the two
door hinges.
and at the
Lift and turn the
2
levers on the two
hinges.
www.zanussi.com